|
LIFT
FRAME REMOVAL
Always
unplug chair from outlet first! If possible,
flip chair upside down on a saw horse, this
will make it easier for lift frame removal.
1)
After having chair upside down, there will
be 4 or 8 7/16 x 2-1/2" lag screws
mounting lift frame to the bottom of the
arms of the lift chair. Remove lag screws by
turning counter clockwise.
2) Open the footrest and you will see 3
clevis pins. Remove the clevis pin
connecting the top piece to the recline bar.
3) Cut ty wraps holding handwand cord to
lift frame and unplug cord from motor
assembly. Pull handwand cord free and clear
of lift frame.
4) Lift out lift frame by grabbing both
lower base and top piece at the same time.
This will prevent lift frame from opening
when lifting.
TO
REINSTALL LIFT FRAME INSTALLATION
OF LIFT FRAME
1)
Having chair upside down grab lift frame by
lower base and top piece and place the lift
frame into lift chair motor side down and
gear casing towards the back of lift chair. DO
NOT bolt the lift frame down yet!
2) Go to the front of the chair and open the
footrest about 10" to 12 inches,
install clevis pin with washers and spacers
into recline bar and lift frame recline bar
brackets. See diagram.
3) Once clevis pin and hair pins are in
place, close foot board. The lift frame
should go back to it's original position to
align the holes in lift frame to the holes
in wood frame. Insert nylon washers between
the metal lift frame and wood arm of chair,
bolt the lift frame down using 2-1/2"
lag bolts.
4) Place chair back over upright, test chair
for ride.
|
